Category Archives: Sensors

G-RX8 – Redundancy & Variometer

      Comments Off on G-RX8 – Redundancy & Variometer

OpenTX Receiver & Sensor FrSKY G-RX8 (USA World) Description Has a built in variometer sensor Has redundancy capability where a second receiver may be connected Setup Binding 2 Receivers (Redundancy) For the second receiver use any receiver with an SBUS out. Turn on the Tx Press MENU Scroll down and select… Read more »

RPM – Setup

      Comments Off on RPM – Setup

OpenTX Sensor FrSKY RPM Sensor (USA World) Displays RPM (Revolutions Per Minute) Motor Details Determine the number of magnetic poles (blades in OpenTX) Emax MT1806-2280KV Framework 12N14P 14P = 14 Magnets = 7 Pole Pairs = 7 blades in OpenTX Note the KV 2280 revolutions per minute per volt Setup… Read more »

GPS – Setup

      Comments Off on GPS – Setup

OpenTX Sensor FrSKY GPS (USA World) Displays Speed mph, kmh, ft/s, m/s, knots Latitude & Longitude degrees, minutes, seconds, decimal Altitude Date & Time Setup Connection diagram GPS Turn on Tx Power up Rx with sensor connected Press MENU Long press PAGE If GSpd, GPS and GALT are not visible scroll down (-) until… Read more »

Current – Setup (FAS40S)

      Comments Off on Current – Setup (FAS40S)

OpenTX Sensor FrSKY Current Sensor (USA World) Displays LiPo Voltage V Current mA Setup Connection diagram FAS40S Turn on Tx Power up Rx with sensor connected Press MENU Long press PAGE Repeat till the TELEMETRY screen is displayed Select “Discover new sensors” Press ENTER New sensors will be added to the… Read more »